Carl Valentin DPM IV, Руководство по эксплуатации

Страница: 56 / 110

Function Menu DPM IV
56 Operating Manual 05.18
6.11.3 Ribbon Service
Selection of the used transfer ribbon length (see Technical Data). With
smaller ribbons, a higher number of cycles can be reached.
Selection of the coating side of transfer ribbon, either outside or
inside.
Default: Coating outside
Ribbon prior warning: Before the end of transfer ribbon, a signal is
send by the control output.
Ribbon prior warning diameter: Setting of transfer ribbon advance
warning diameter.
In case you enter a value in mm then a signal appears via control
output when reaching this diameter (measured at transfer ribbon roll).
Ribbon prior warning mode:
Warning:
When reaching the transfer ribbon advance warning
diamter, the corresponding I/O output is set.
Error: The printing system stops when reaching the transfer ribbon
advance warning diameter with the message 'too less ribbon'.
Speed: Setting of the reduced print speed in mm/s. This can be set in
the limits of the normal print speed.
Roll diameter: Indication how much transfer ribbon is still on the
transfer ribbon roll. For a correct display some layouts must be
reprinted.
Time left: Indication during a current print order, how long it can be
printed with the existing transfer ribbon.
6.11.4 I/O Status
The start input impulses are counted directly at the Interrupt.
The start input impulses that are longer than the set debounce time
are counted. Only these start impulses can lead to a print. If a start
impulse is too short, no print is released. This is recognized by the fact
that RInt is counted, Dbnc not.
The debounced start input impulses that have not lead to a print are
counted. Causes: no active print order, print order stopped (manually
or because of an error) or the printing system is still active with the
processing of a print order.
The counters are reset.
Measured length of the last start impulse in ms.
Length and ink side
Prewarning
Current diameters
PrtStrtIntsReal
PrtStrtIntsDebounced
PrtStrtIntsNoPrint
PrtStrtReset
PrtStrtTime