Carl Valentin DPM IV, Руководство по эксплуатации

Страница: 100 / 110

Error Correction DPM IV
100 Operating Manual 05.18
Error message Cause Remedy
81 IGP error
Protocol error IGP. Check sent data.
82 Time generation
Printing creation was still active
at print start. Reduce print speed.
Use printers' output signal for
synchronisation.
Use bitmap fonts to reduce
generating time.
83 Transport protection
Both DPM position sensors
(start/end) are active. Displace zero point sensor
Check sensors in service
functions menu
84 No font data
Font and web data is missing. Run a software update.
85 No layout ID
Label ID definition is missing. Define label ID onto the label.
86 Layout ID
Scanned data does not
correspond to defined ID. Wrong label loaded from CF
card.
87 RFID no label
RFID unit cannot recognise a
label. Displace RFID unit or use an
offset.
88 RFID verify
Error while checking
programmed data. Faulty RFID label.
Check RFID definitions
89 RFID timeout
Error at programming the RFID
label. Label positioning.
Faulty label.
90 RFID data
Faulty or incomplete definition
of RFID data. Check RFID data definitions.
91 RFID tag type
Definition of label data does not
correspond with the used label. Check storage partitioning of
used label type
92 RFID lock
Error at programming the RFID
label (locked fields). Check RFID data definitions.
Label was already
programmed.
93 RFID programming
Error at programming the RFID
label. Check RFID definitions.
94 Scanner timeout
The scanner could not read the
bar code within the set timeout
time.
Defective printhead.
Wrinkles in transfer ribbon.
Scanner wrong positioned.
Timeout time too short.
Check printhead.
Check transfer ribbon.
Position scanner correctly,
corresponding to the set
feeding.
Select longer timeout time.