Carl Goldberg Products EXTRA 300, Инструкция по эксплуатации

Страница: 15 / 44

15
5.
■ ■
Scissors-pin a 3/8” sq. BASSWOOD SPAR over the
plan, as shown. Make sure that the end is on the plan
centerline.
6.
■ ■
Pin tabbed Rib #2, #6, and #10 over the plan, but DO
NOT GLUE at this time.
7.
■ ■
Place the notched T.E. on the support tabs, with the cut
end at the centerline. Press the ribs into the notches
and glue.
■ ■
Remove the other ribs from their sheets.
IMPORTANT: Save the “horseshoe”- shaped punch out in
Rib #4, as you will need it for Step #29.
■ ■
Place the remaining ribs into the notched T.E. and onto
the spar, but DO NOT GLUE. Make sure that you
correctly install Rib #7, as shown. Match the bellcrank
support slot direction to Rib #6.