Carl Goldberg Products EXTRA 300, Инструкция по эксплуатации

Страница: 37 / 44

37
4.
■ ■
Pretrim the back flip-up portion of the cockpit insert.
■ ■
Glue the top of the frame and place the insert in
position.
■ ■
Trim the insert flush with the outside of the rails.
■ ■
Add control sticks and pilot (both not included in kit), if
desired. Also, paint the interior at this time.
5.
■ ■
Trim the canopy along the scribe line. You may want to
trim it a little long and precisely fit it to the wing and
fuselage.
6.
■ ■
Paint the canopy deck up to the canopy crease.
ASSEMBLING THE WHEEL PANTS (6 Steps)
1.
■ ■
Clean up the edges of the pant halves by gently sliding
them over sandpaper on a flat surface.
2.
■ ■
On both the outer and the inner pant half, drill a 3/16”
hole at the axle location.
■ ■
Glue the two support plates to the inner pant half.
■ ■
Glue the axle support plate to the outer pant half,
aligning the center mark on the plate concentric with
the hole.
3.
■ ■
Rough-cut the wheel opening in all four pant halves.
Then glue an outer half to an inner half, forming a lap
joint. Align the outer half edge to the scribe line on the
inner half all around.