Carl Goldberg Products EXTRA 300, Инструкция по эксплуатации

Страница: 23 / 44

23
31.
■ ■
Cut out the opening for the aileron servo as you install
the center sheeting.
NOTE: IF YOU ARE USING THE TWO-SERVO OPTION, CUT
A SMALLER OPENING FOR SERVO LEAD ACCESS
ONLY.
■ ■
Glue the tip sheeting in place and install the capstrips.
■ ■
Remove the wing assembly from the building board.
32.
■ ■
Sand flat the end ribs and glue the balsa tip rib to both
tips.
■ ■
Sand the perimeter to match the airfoil.
33.
■ ■
Sand the wing, blending all the seams and joints. Use
a tack rag to remove all of the dust when finished.
34.
■ ■
Starting at the front of the servo cut-out, completely
wrap the center of the wings with 3/4” nylon tape. Smear
glue through the fabric weave, using a plastic bag to
protect your finger.
■ ■
Trim the excess at the rear servo cut-out.