Carl Goldberg Products EXTRA 300, Инструкция по эксплуатации

Страница: 4 / 44

4
PARTS IDENTIFICATION
WOOD PARTS
Be careful Men removing parts (such as fuselage sides) from the
die-cut sheets. Long parts are fragile until glued into a structural
unit. If necessary, use a razor knife or razor saw to assist in the
removal of parts from the sheet. Sometimes a little trimming and
sanding can improve parts, Mere desired. Save scrap until the
model is completed, in case a part is missing or damaged. Also,
scrap is used in some building steps.
ABOUT THE WOOD IN THE KIT
We strive to supply good quality materials in your kit. Wood parts
are inspected with regard to the function they will serve. If an
imperfection is spotted in a scrap corner of a die-cut sheet and
doesn’t affect actual parts, the sheet is considered acceptable.
Also, internal stresses in wood are relieved as it is cut into parts.
These relieved stresses may cause some parts to bow. Bows in
wood parts (such as leading edges) readily straighten out as they
are glued into a structural unit