Carl Goldberg Products EXTRA 300, Инструкция по эксплуатации

Страница: 25 / 44

25
2.
■ ■
Laminate the two ply front platform supports and glue
to the spar, centering between Ribs #6 and #7.
■ ■
Glue the rear platform support to Ribs #6 and #7 and
to the T.E. sheeting.
3.
■ ■
Drill a 1/16” diameter hole in each corner of the platform
and mount to the rails, using four of the #2 x 5/16”
screws and washers.
4.
■ ■
Glue the corner gussets to the servo mounts and fasten
the assemblies to a servo.
5.
■ ■
Glue a corner gusset to each corner of the servo bay,
as shown.
■ ■
Fabricate the balsa hatch and drill a 1/16” diameter hole
in each corner.
■ ■
Center the servo arm in the slotted hole of the hatch
cover to locate the servo. Remove the hatch and glue
the servo gussets and mounts to the platform.
6.
■ ■
After the wing is covered, and with both the servo and
aileron in the neutral position, measure and connect the
pushrod.
THIS COMPLETES THE WING. NOW LET’S MOVE ON TO THE
FUSELAGE.