Carl Goldberg Products EXTRA 300, Инструкция по эксплуатации

Страница: 14 / 44

14
NOTE: IF USING AN ENGINE LARGER THAN A.60 2-CYCLE,
YOU WILL WANT TO FOLLOW THE INSTRUCTIONS FOR THE
TWO SERVO OPTION, WHICH ARE FOUND IMMEDIATELY
AFTER THE WING SECTION.
NOTE:YOU WILL BE BUILDING TWO WING HALVES. DO NOT
BUILD BOTH HALVES OVER THE SAME SECTION OF THE
PLAN. FOLLOW STEPS CAREFULLY TO AVOID
CONFUSION
2.
■ ■
Cut the vying plan along the dotted line. Position the left
wing plan overlapping the right plan, aligning the
arrows as shown. Pin or tape the plan to the building
board and cover with waxed paper,
3.
■ ■
Lay a shaped LEADING EDGE over the plan and cut
the angle at the centerline. Repeat this step on the
other L.E.
■ ■
Next, place the notched TRAILING EDGE over the over
the plan, aligning the notches to insure that you cut the
correct end. Cut the angle at the centerline and then
repeat this step on the other notched T. E.
■ ■
Referring to the plan, cut the inboard T. E. parts to the
correct length and angle.
4.
■ ■
Wrap a piece of fine sandpaper around the 5/16”
DOWEL and sand the wing pin notch into the angle-cut
end of the shaped L.E.