Carbide 3D Shapeoko HDZ 4.0, Инструкция по сборке

Страница: 46 / 62

support@carbide3d.com docs.carbide3d.com
8/31/2020 Version 4.0
46
Disconnect the Proximity Switches and X-Axis Drag Chain Head and Remove the Z-Plus
See Fig. 4 (front) and Fig. 5 (back).
1. Remove the Z-Axis proximity switch from the front
of the Z-Plus.
a. Disconnect the Z-Axis proximity switch
from the gray Z-Axis proximity switch
extension cable.
b. Use a 2.5mm hex key to remove the two
(2) M3
×
18mm SHCS.
c. CARRY OVER the Z-Axis proximity switch.
2. Remove the X-Axis proximity switch from the
switch plate on the rear of the Z-Plus.
a. Use a 2.5mm hex key to remove the two
(2) M3
×1 8mm SHCS securing the switch to
the plate.
b. CARRY OVER the X-Axis proximity switch
(installed in drag chain).
3. Remove the Y-Axis proximity switch from the
switch plate on the outside of the Y2-carriage.
a. Use a 2.5mm hex key to remove the two
(2) M3
×1
8mm SHCS securing the switch to
the plate.
b. CARRY OVER the Y-Axis proximity switch
(installed in drag chain).
4. Remove the Y-Axis proximity switch plate and two
(2) standoffs from the outside of the Y2-carriage.
a. Use a 4mm hex key to remove the two (2) M5
×
8mm SHCS securing the plate.
b. Remove the two (2) 30mm standoffs.
5. Disconnect the X-Axis drag chain from the X-Axis head bracket on the rear of the Z-Plus.
a. Use a 2mm hex key to remove the two (2) M3 × 6mm FHS securing the drag chain to the head bracket.
b. Drape the drag chain over the Y1-carriage to get it out of the way (no need to disconnect the tail end).
6. Remove the lower two (2) V-wheels from the Z-Plus.
Figure 4
Figure 5
Shapeoko 3 Machines: Disconnect the Z-Axis
proximity switch from the Carbide Motion board.
Shapeoko 3 Machines: Skip 5 and move ahead to 6 on the next page.