Carbide 3D Shapeoko HDZ 4.0, Инструкция по сборке

Страница: 24 / 62

support@carbide3d.com docs.carbide3d.com
8/31/2020 Version 4.0
24
Insert the Proximity Switch Cables into Drag Chain
Install the Proximity Switch Cables
HDZ Kit:
Item Description Qty
P X-Axis Proximity Switch Cable (2675mm XXL and 2350mm XL) 1
Q Y-Axis Proximity Switch Cable (2540mm XXL and 2200mm XL) 1
S Z-Axis Proximity Switch Extension Cable (2438mm XXL, 2235mm XL) 1
1. Open up the drag chain and remove the black and yellow homing switch cables. See Fig. 22 and Fig. 23 .
a. Position the drag chain on the baseframe
as shown in
Fig. 23 , with the chain ’ s clip-on
panels facing up. (Only one side of the
chain will open; be sure this side is facing
up.)
b. Use a hex key or screw driver as a lever to
pry open one side of each drag chain link.
Start from the rear of the machine and
work your way forward as shown in
Fig. 22 .
c. Remove the three black and yellow X-, Y-,
and Z-Axis homing switch cables.
2. Label the proximity switches AND gray 3-pin
extension cable.
a. Identify the X- and Y-Axis proximity
switches by comparing the length printed
on the switch body with the table above.
b. Use a permanent marker or piece of tape
to label the white female connectors of
X- and Y-Axis proximity switch cables AND
the gray Z-Axis proximity switch extension
cable.
Figure 23
Figure 22