Capintec CAPTUS 600, Руководство пользователя, Страница: 12 / 218

CAPINTEC, INC. CAPTUS
®
600
WARNING AND CAUTION LABELS
Located in the center section on both sides of the spring-arm of the floor stand is a warning
label, (Figure 1-1), concerning the hazard of removing the collimator when the spring-arm is
in the wrong position. When the weight of the collimator is removed from the spring-arm, the
arm can forcefully spring upward and cause serious bodily injury to the operator. The spring-
arm must be fully extended in the upright position to prevent this hazardous condition.
Figure 1-1
Located in the front section on both sides of the spring-arm of the floor stand is a warning
label, (Figure 1-2), concerning the hazard of improperly installing the collimator onto the
spring-arm. If the collimator support pin is not fully inserted and latched into the receptacle
block of spring-arm, the collimator may detach from the spring-arm and fall onto the patient.
In addition, the arm can, again, forcefully swing upward and cause serious bodily injury to the
operator. The collimator is safely installed on the spring-arm when the red warning ring is
NOT visible between the collimator and the receptacle block. Refer to the UNPACKING AND
ASSEMBLY INSTRUCTIONS for illustrations.
Figure 1-2
Located on the top of the Isolation Transformer is a label, (Figure 1-3), providing the system
power requirements, the voltage and serial number of the system and the replacement fuse
values for both power line voltages.
Please reference CHAPTER 20: CLEANING AND MAINTENANCE for instructions on how to
change the fuses on the CAPTUS
®
600 Isolation Transformer.
A fire hazard may exist if the wrong size of fuse is installed.
1-2 SAFETY November 07