Canon PIXMA MP530, Руководство по обслуживанию, Страница: 40 / 91

3-3. Adjustment / Settings
(1) Paper feed motor adjustment
Perform the following adjustments when the paper feed motor unit is replaced:
1) When attaching the motor, fasten the screws so that the belt is properly stretched (in the direction indicated by the blue arrow
in the figure below).
2) After replacement, be sure to perform the service test print, and confirm that no strange noise or faulty print operation (due to
dislocation of the belt or gear, or out-of-phase motor, etc.) occurs
Note: The red screws securing the paper feed motor may be loosened only at replacement of the paper feed motor unit. DO
NOT loosen them in other cases.
(2) Grease application
1) Machine unit
*1 drop = 9 to 18 mg
No Part name Where to apply grease/ oil
Grease/ oil
name
Grease/ oil
amount
Number
of
drops*
Number of
locations to
apply grease/
oil
1 Chassis ass'y Entire surface the carriage slider contacts Floil KG107A 27 to 54 mg 3 1
2 Chassis ass'y PR lift shaft cam contact portion (at 3 locations) Floil KG107A 9 to 18 mg 1 3
3 Adjust plate L Carriage shaft cam L sliding portion Floil KG107A 18to 36 mg 2 1
4
Chassis ass'y Carriage shaft sliding portion on the left side
of the chassis (at 2 locations) Floil KG107A 9 to 18 mg 1 2
5
Chassis ass'y Carriage shaft sliding portion on the right side
of the chassis (at 2 locations) Floil KG107A 9 to 18 mg 1 2
6
Carriage shaft Entire surface of the carriage shaft where
the carriage unit slides Floil KG107A 200 to 400 mg 1
7
Carriage shaft spring L Carriage shaft sliding portion
(to the end of spring) Floil KG107A 9 to 18 mg 1 1
8 Adjust plate R Carriage shaft cam R sliding portion Floil KG107A 18 to 36 mg 2 1
9
Carriage shaft Carriage shaft surface where the carriage sliders
(and where machine-application of the grease
is not feasible) Floil KG107A 9 to 18 mg 1 1
1-35