Canon PIXMA MP530, Руководство по обслуживанию, Страница: 13 / 91

Note: Before replacement of the logic board ass'y, check the waste ink amount (by service test print or EEPROM information
print). If the waste ink amount is 7% or more, also replace the ink absorber kit when replacing the logic board ass'y. [See
Section 3-3. Adjustment / Settings, (6) Service mode , for details.]
2-3. Fax Errors
For errors other than those listed below, please refer to the " G3 / G4 Facsimile Error Code List (Rev. 2). "
(1) User error codes
9 times EEPROM
error [6800] A problem occurred in writing to the EEPROM. - Logic board
11 times Carriage lift
mechanism
error [5110] The carriage did not move up or down properly. - PR lift shaft
- Sheet feed unit
- Logic board
- Carriage lift sensor unit
12 times AP position
error [6A00] An error occurred in the AP motor during
purging operation.
- Sheet feed unit
- Logic board
- Purge unit
13 times Paper feed
position error [6B00] An error occurred in the paper feed motor.
- Sheet feed unit
- Logic board
14 times Paper feed
cam sensor
error [6B10] An error occurred in the paper feed cam sensor
during paper feeding from the front paper feed
cassette.
This error is also indicated when the waste ink
counter is 60% or more, and a paper jam occurs
in the under guide.
- Sheet feed unit
- Logic board
15 times USB Host
VBUS
overcurrent [9000] The USB Host VBUS is overloaded. - Logic board
16 times Valve sensor
error [6C00] An error occurred in the valve sensor during
cleaning.
- Logic board
- Purge unit
17 times Motor driver
error [6D00] The AD conversion value indicating the motor
driver temperature is not proper.
- Logic board
19 times Ink tank
position
sensor error [6502] None of the ink tank position is detected.
- Platen unit
- Logic board
20 times Other
hardware error [6500] The PCI bus error is detected by the ASIC. - Logic board
22 times Scanner error [5010] The scanner unit cannot detect the home
position, or the scanner unit warming-up is not
done properly at power-on.
On the LCD, "SCANNER ERROR" is
displayed.
- Scanner unit
Continuous
alternate blinking ROM error [6100] The check sum value is incorrect in the ROM
check at hard-power-on.
- Logic board
Alarm LED lit RAM error [6300] The RAM error occurred in the RAM check at
hard-power-on.
- Logic board
Error code TX / RX Meaning
#001
TX Document jam
#003
TX / RX Document is too long, or page time-over
#005
TX / RX Initial identification (T0 / T1) time-over
1-8