Protocol Settings
2-9
2
Using a
TCP/IP Netw
or
k
5
Enter the address settings.
Enter the address settings using the
keypad on the control panel.
IMPORTANT
• For information on entering characters
using the touch panel display, see the
User's Guide
.
• Only one of the DHCP, BOOTP, or RARP
settings can be checked at one time.
• Even when using the DHCP, BOOTP, and
RARP settings, you should enter an IP
Address, Subnet Mask, and Gateway
Address. If this information cannot be
obtained from the DHCP, BOOTP, or
RARP server, the settings entered from
the control panel are used.
• When using DHCP, it is recommended
that identical IP address be assigned to
the machine at all times. (If the identical IP
address is not assigned, the machine’s
host name cannot be related to the
machine’s IP address.)
• It takes about two minutes to check
whether the DHCP, BOOTP, or RARP set-
tings can be used. If you do not plan to
use one of these settings, it is recom-
mended that you turn them off.
●
Using a fixed IP address
Press the [IP Address] key, and enter
the IP address using the keypad.
●
Using DHCP
Press the [Enable DHCP] key. Enter
the IP Address, Subnet Mask, and
Gateway Address. (If this information
cannot be obtained by the DHCP, the
settings entered from the control panel
are used.)
●
Using RARP
Press the [Enable RARP] key. Enter
the IP Address, Subnet Mask, and
Gateway Address. (If this information
cannot be obtained by the RARP, the
settings entered from the control panel
are used.)
00̲MFPNG.book 9 ページ 2000年4月26日 水曜日 午後5時11分
Содержание IR3250
