Canon imagePRESS C10000VPSeries, Руководство по устранению неисправностей

Страница: 203 / 265

Points to note when installing, removing and cleaning the primary
corona assembly
[Symptom]
E060-0x01 or black lines on image may occur due to deformation of the parts in the primary corona assembly caused by
installation, removal and cleaning of the primary corona assembly.
- E060-0x01 : Primary Charging Wire error (y = 1:Y, 2:M, 3:C, 4:Bk)
[Service work]
Be sure to pay attention to the points noted below when performing the following work.
A) When holding the primary corona assembly with hands
B) When placing the primary corona assembly on a working table
C) When loosening the yellow screws in the slider
D) When removing and installing the shutter
E) When opening and closing the shutter manually 1
F) When opening and closing the shutter manually 2
A) When holding the primary corona assembly with hands
When holding the primary corona assembly with hands, hold it by the handle. (black molded part) When holding the center of the
shield plate as shown in the photo, the shield plate deforms. Using the unit in this state causes a load to the slider [1] around the
center section when the slider [1] moves causing it to stop. As a result, E060-0x01 may occur.
B) When placing the primary corona assembly on a working table
When placing the primary corona assembly on a working table, the leaf spring [1] of the shutter may deform as shown in the
photo [A] if placing the unit with the etching grid plate facing down. The photo [B] is the leaf spring [2] in a normal state. When
the leaf spring deforms, E060-0x01 may occur because it gets stuck to the etching grid plate when the shutter moves.
[Reference] When placing the unit with the etching grid plate [1] facing down, foreign material may attach to the etching grid plate.
When placing the primary corona assembly on a working table, be sure to place it with the etching grid plate facing up.
198