Canon imagePRESS C10000VPSeries, Руководство по устранению неисправностей

Страница: 107 / 265

a-7) Remove the tension spring [1], the E-ring [2] and the bearing [3].
a-8) Remove the transmission shaft together with the drive swing plate from the upper delivery guide assembly. Remove the 3
E-rings, the 2 bearings, the gear and the dowel pin from the transmission shaft. Then, remove the drive swing plate and rest of
the gears.
a-9) Apply about the size of a rice grain (20mg) of super lube grease to each area of where the bearings are engaged (3 colored
areas indicated with arrows) of the new type transmission shaft (FE8-3616-010). Then, reassemble the parts removed in the step
a-8).
[Note] When applying super lube grease to the transmission shaft, be sure not to apply it to any areas of the shaft other than
where the bearings are engaged.
a-10) Attach the parts in the reverse order from the step a-7) to the step a-1).
If continuing on to replace the transmission shaft in the lower delivery guide assembly, proceed to the step b) below.
If replacing the transmission shaft in the upper delivery guide assembly only, attach the parts in the reverse order from the step
4) and complete the work.
[Note] When attaching the parts, apply about the size of a rice grain (20mg) of super lube grease to the area where the transmission
shaft and bearing are engaged [a] right before attaching the bearing and the E-ring removed in the step a-6). Be careful of the
timing of applying the super lube grease.
102