Canon FAX-L380S Series, Руководство по обслуживанию

Страница: 152 / 176

Chapter 5
5-22
T-5-21
No.010
Use it to set the length of time for line connection identification.
If an error occurs often because of the line condition at time of a communication, increase the parameter.
Memo
The line connection recognition time means the period from transmission of dial signal to detection of significant signal for the transmission end, and the
period from transmission of DIS signal to detection of significant signal for the receiving end.
No.011
Set the T1 timer for the receiver (wait time after DIS transmission starts until a significant signal is received).
If frequent errors occur during reception because of line connection conditions, increase the value of this parameter.
No.013
Set the maximum receivable time per line of image data when receiving image data. If the other party is a computer fax and the like, and the image data
reception time per line is longer, increase the value of this parameter to lengthen the maximum receivable time.
No.028
Use it to set the length of time during which the menu select screen is indicated on the LCD.
In the meantime, the length of time during which the registration and setting screen is indicated is fixed.
5.5.6 Counter Indication (COUNTER)
5.5.6.1 #9 COUNTER
0011-5270
/ / FAX-L390 / / / FAX-L380S
Display the counter readings of scanning, printing, communication, and copy.
5.5.7 Report Output (REPORT)
5.5.7.1 #10 SERVICE REPORT
0011-9446
/ FAX-L390 / / / FAX-L380S
This fax outputs the service data setting status, past communications history reports, detailed error information reports, etc. in service mode.
List of service reports
This fax outputs the service reports shown below.
T-5-22
System data list
This list shows service data setting statuses of service soft switches and service parameters.
No. Function Selecting range Default
setting
010 Line connection identification time length 0 to 9999 (10ms) 5500
011 T.30 T1 timer (for reception) 0 to 9999 (10ms) 3500
013 Maximum time to receive one line of image data 500 to 3000 (10ms) 1300
028 Menu select screen display time length 1 to 60 sec 3
Report type Operations
System data list In the service mode, select #10 SERVICE
System dump list REPORT menu, and press OK button.
Key history report Then select the report type, and press
Counter report OK button.
Print spec report
Service Tx/RX report
(with service error code and dump list) If you set bits 0 and 1 of #1 SSSW SW01 in the service mode, the
service error code and dump list are indicated on the TX/Rx report.