Cabletron Systems MMAC-Plus 9F116-01, Руководство пользователя, Страница: 280 / 420

16-4 FRX/FRM 3. 3 User G uide, Rev 04
Exiting Remote Control
Press
[,]
(comma) to exit remote control. When asked:
Stop remote control?
, press
[Y]
.
Node Name="NN"
(where
"NN"
is the
Node Name
configured in Node Defaults) will be
displayed in the upper right hand corner at the remote node, meaning that the remote
node is now under local control (control at its own screen).
If the controlled node detects that the remote control line failed during a remote
control session, remote control will be terminated and the remote node's local Main
Menu will be displayed on its screen.
Remote File Transfer
This operation copies a file from one FRX/FRM to another.
This operation requires either physical X.25 ports or logical X.25 (on
physical frame relay) ports on each device.
Before a file transfer is performed to or from this node, make sure a
File
Transfer ID
is specified in Node Defaults. (See Chapter 3.)
Press
[B]
at the On-Line Node Operations Menu (or
[B], [A], [B]
from the Main Menu).
When prompted, enter:
●
File Transfer ID
and
File Transfer Pwd
(password) of the remote node to which
you are copying the file.
●
Source File Name
(the existing name of the file you want to transfer).
●
Destination File Name
.
The transfer process is as follows:
1. The originating node will send a message that includes a request for the file name
and size.
2. The remote node will check to make sure there is enough disk space to accept the
file; if not, the connection will be cleared and a corresponding message displayed.
3. If there is enough disk space, the file will be transferred, and stored in the remote
node under a temporary file name until the node verifies that the file is the
expected size. If not, the temporary file will be deleted.
As a file transfer progresses, you can press
[F4]
at any time to abort the transfer
and clear the connection.
4. If the temporary file is the expected size, any existing file with the same name will
be deleted and the temporary one will be renamed the destination file name that
was specified.
5. Once the transfer is complete, the sending node will clear the connection.