Cabletron Systems MMAC-Plus 9F116-01, Руководство пользователя, Страница: 132 / 420

7-14 FRX/FRM 3. 3 User G uide, Rev 04
Configuring Subscriber Addresses
This operation configures the called and calling addresses that will be used in call
setup. To complete the connection, the software must recognize where the call is
coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press [A] at the Connections and
Routing Paths Menu (or [A] , [D] , [A] from the Main Menu).
To add or change a Subscriber ID, press [B] at the Connections and Routing Paths
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described in Appendix A.)
Figure 7-5 Typical SVC Subscriber Screen
[A],[D],[B] from Main Menu
If configuring an ID that will be a
Source Subscriber
on an IP (over X.25)
Interface (described in Chapter 11), accept the default values for all param-
eters after
Subscriber Name
, and do not configure any Routing Path. If con-
figuring an ID that will be a
Destination Subscriber
on an IP (over X.25)
Interface, accept the default values for all parameters after
Subscriber
Name
, except
1st Routing Path
, which must be configured as the node, RLP,
and physical X.25 port that will be used as the interface.
Pressing
[G]
will display routing paths, which link the subscriber with one or more
ports. Pressing
[H]
will display the addresses used for call redirection. (These
addresses are valid only if
Y
is specified for one or more of items C, D, and E on the
first screen.) Parameters for all three screens are described following Table 7-4.
Node N ame= nod exyz
SVC S ubs criber Maintenan ce
*
S ubs criber ID 0100012345
A S ubs criber Name sub 1
B R outing A lgorithm 0, Roun d R obin
C S ystematic R ed irection N
D R ed irect on Busy N
E R ed irect on Ou t of Order N
F C onnection Priority 0
G R outing Paths
H R ed irection Add ress es
Op tion :