Page 20
29877 080301
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET PULSE BREW:
This function allows the operator to program the
brewer to "pulse” the sprayhead flow on and off dur-
ing a brew cycle (start and stop the flow of water out
of the sprayhead). This feature allows the ability to
“fine-tune” the brewer for specific flavor profiles. Pulse
brewing can be set up for any and all batches.
a)
1st ON TIME
- This time is the duration from when
the
pad is pressed to when the desired water
level in the funnel is reached. (Soaking the
grounds)
b)
OFF-TIME -
This time is the duration from when
the water in the funnel reaches the desired
ON
TIME
level to when it drains out of the funnel to a
desired lower level.
c)
LAST ON-TIME
- This time is the duration from when
the water in the funnel drains down to the lower
level to when it fills the funnel to a desired higher
level. (Soaking the grounds).
These three times can be set two different ways.
The first is by observing the flow of water for on and
off times. This is accomplished by utilizing the
SET
BY EXAMPLE
screen and following the subsequent
steps under that function.
The other allows the actual times to be entered
for each of the settings. This is done by utilizing the
ENTER TIMES
screen and following the subsequent
steps under that function.
Either of these methods can be used to set the
pulse brew for each batch.
P2293
Modifying pulse brew:
Range: 1st on time
- off to 4 minutes
Off time
- off to 4 minutes
Last on time -
Preinfusion to 4 minutes
NOTE:
If the brewer is already in the
SET PULSE BREW
screen, it is not necessary to follow steps 1 through 8
in this section, but proceed directly to step 9.
1. Press and hold the ® pad until the display reads
SET NEW RECIPES.
Release the ® pad. Press the
® until the display reads
REVIEW RECIPES
.
2. Press
YES
to proceed. The display should now
read
NO-NAME LEFT,
along with
MODIFY, SHOW
and
NEXT.
3. Press and release
NEXT
to advance to the desired
coffee name to be modified.
4. Press and release
MODIFY.
The display should
read
BREW OZ.
5. Press and release
DONE
. The display should read
3 BATCHES DONE?
.
6. Press and release
YES
. The display should now
read
% BYPASS.
7. Press and release
DONE
. The display should read
3 BATCHES DONE?
.
8. Press and release
YES.
The display should now
read
SET PULSE BREW.
9. Press and release
YES.
The display should now
read
SET BY EXAMPLE.
10. If setting pulse brew
BY EXAMPLE
(brewing into a
funnel) press
YES
and proceed with the setup
instructions for
SETTING PULSE BREW - BY EX-
AMPLE, on page 22.
11. If setting pulse brew by
ENTER TIMES
(entering
known times) press
NO
. The display should read
ENTER TIMES.
Press and release
YES
and pro-
ceed with the he setup instructions for
SETTING
PULSE BREW - ENTER TIMES, page 23.
