Page 16
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
29877 080301
SET NEW RECIPE:
If not using a Smart Funnel
®
(with a sensor coil) and/
or a G9-2T DBC Grinder, the brewer will function as
a standard Bunn
®
Dual
®
Brewer:
It is possible to operate the brewer without using
a Smart Funnel
®
and/or a G9-2T DBC Grinder. If a
standard funnel, or if a non-DBC grinder is used the
brewer will automatically select a
NO NAME
coffee
flavor when the
pad is pressed. This means that
no name was read from the funnel's handle.
There are two
NO NAME
coffee programs that can
be set in the brewer. They are referred to as
NO NAME
LEFT
and
NO NAME RIGHT
. The left and right sides of
the brewer can be set up independently of each other.
This includes
BREW VOLUMES, BYPASS PERCENT-
AGES, PULSE BREW TIMES, PREINFUSION TIMES
and
DRIP-OUT TIMES
. The brewer will perform in the
same capacity as a standard Bunn Dual
®
Brewer.
The instructions for programming the
NO NAME
settings are on the following pages. The same steps
are followed for setting the recipe as those that are
used to
MODIFY A RECIPE
, beginning on page 18.
Note that when the display reads
NO NAME LEFT
,
that is when
MODIFY
should be pressed in order to set
the parameters for the
NO NAME LEFT
coffee.
Otherwise, press
NEXT
to display
NO NAME RIGHT.
At this point,
MODIFY
should be pressed in order to set
the parameters for the
NO NAME RIGHT
coffee.
NOTE:
Before beginning setup, insert a funnel into the
left and right side funnel rails, and place a Soft Heat
®
Server beneath each brew funnel.
P2419
