BullFrog 2001 Portable Spas, Руководство пользователя

Страница: 8 / 42

Page 8 Bullfrog Spas Owner’s Manual
ELECTRICAL REQUIREMENTS &
HOOK-UP
All Bullfrog Portable Spas must be wired in accordance
with all local & national electric codes. Have a licensed
electrician perform the electrical installation.
Important: All metal enclosures, pipe or conduit
located within 5 feet (1.5m) of the spa must be bonded
to the Control Center Box located inside the equipment
compartment of the spa. The wire used to complete this
bonding must be a minimum No. 8 (8.4mm²) solid
copper wire. It is to be connected to the ground lug
connector on the exterior surface of the Control Center
Box and all metal items described above.
WIRING DIAGRAMS
Please reference the wiring diagram that is specific to
your spa’s Control System:
•
Standard Control System/BULF65 (Fig. C)
•
Deluxe Control System/BULF70 (Fig. D)
•
Limited Control System/BULF75(Fig. E)
120V/240V CONVERTIBLE EQUIPMENT
Unless you special ordered 120 Volt equipment, your
Bullfrog Portable Spa comes standard as a 240 Volt spa.
If your spa is equipped with a Standard Control System
(BULF65), it can be wired as either a dedicated 120V or
240V system.
With the 120 Volt Standard Control System, you can
take advantage of the Bullfrog PowerPlus feature by
upgrading your 120V system to a more powerful 240V
system. The 240V system allows you to increase
horsepower as well as heating capacity.
For specific conversion instructions, please refer to the
system wiring diagram locating inside of the control
system box.
120 VOLT INSTALLATION
Use only a qualified Licensed Electrician to make 120
Volt electrical installations.
Your 120 Volt spa requires a dedicated GFCI 20 AMP
electrical circuit and a minimum supply wire size of 12
gauge. It is important that this circuit is dedicated (not
being used by any other electrical appliance) or your
spa may not function properly.
Position your Bullfrog Portable Spa at least 5 feet (1.5m)
from all electrical outlets or devices.
240 VOLT INSTALLATION
Use only a qualified Licensed Electrician to make 240
Volt electrical installations.
(Figure C) Standard 120V/240V Wiring
Diagram