BullFrog 2001 Portable Spas, Руководство пользователя

Страница: 18 / 42

Page 18 Bullfrog Spas Owner’s Manual
Warning! Shock Hazard! No User Serviceable Parts.
Do not attempt service of this control system. Contact
your authorized Bullfrog Portable Spa Dealer for
assistance. Follow all owner’s manual power connection
instructions. Installation must be performed by a
licensed electrician and all grounding connections must
be properly installed.
LIMITED CONTROL SYSTEM
MASTER CONTROL PAD (Fig. N)
Temp Set (80°F - 104°F)
The start-up temperature is set at 100°F/37.5°C. The
last measured temperature is constantly displayed on
the LCD. Note that the last measured spa tem-
perature displayed is current only when pump 1 has
been running for at least 2 minutes.
Press the “Warm” or “Cool” button once to display the
set temperature. Each time either button is pressed
again, the set temperature will increase or decrease
depending on which button is pressed. After three
seconds, the LCD will automatically display the last
measured spa temperature.
Time
When time hasn’t been programmed, the “TIME” icon
flashes. To set the time, press “Time” and follow
prompts, using the “Warm” and “Cool” buttons to adjust
time.
Jets 1
Press the “Jets 1” button once to turn pump 1 on or off,
and to shift between low and high speeds. If left
running, the low speed turns off after 4 hours and the
high speed turns off after 30 minutes. The low speed of
pump 1 runs when pump 2 is on. It may also activate
for at least 2 minutes every 30 minutes to detect the
spa temperature and then to heat to the set
temperature if needed, depending upon mode. When
the low speed turns on automatically, it cannot be
deactivated from the panel; however, the high speed
may be started.
Jets 2
Press the “Jets 2” button once to turn pump 2 on or off,
and to shift between low and high speeds. If left
running, the pump will turn off after 30 minutes.
Chemistry
If your spa has the pH and/or Orp option, you may
check the levels by pressing the “Chemistry” button.
Press once to show the pH level and again to show the
Orp.
Invert
Press the “Invert” button to reverse the display if you
are looking at it and it appears upside down.
(Figure N) Limited Control Pad
(Figure O) Auxiliary Control Pad