BullFrog 2001 Portable Spas, Руководство пользователя

Страница: 10 / 42

Page 10 Bullfrog Spas Owner’s Manual
removing the four screws located in the front.
3. Connect a 1" non-metallic coupling and conduit to
the 1" male CPVC pipe found at the base of the spa
cabinet (see “Parts Identification Diagram” in this
manual).
4. Run the required wires through the conduit and to
the Control Center.
5. Connect the 3 wires (120V systems)/4 wires (240V
systems) to the terminal block located in the Control
Center (see appropriate “Wiring Diagram”).
6. Replace the Control Center face-plate and the
equipment compartment door.
7. The electrical hook-up is complete.
Important: Do not fill or start-up the spa until you have
completed the following section.
(Figure E) Limited 240V Wiring Diagram