BullFrog 2001 Portable Spas, Руководство пользователя

Страница: 19 / 42

Page 19 Bullfrog Spas Owner’s Manual
ac
Light
Press the “Light” button to turn the spa on and off, and
to shift between dim and bright settings if your light is
dimmable. On dim, the light LCD will show center circle
plus one quarter of the light beams. Half of the light
beams will show on medium brightness, and all of the
light beams will show on bright. If the light is left on, it
will automatically turn off after 4 hours.
Standby
Pressing “Standby” will turn off all spa functions tem-
porarily. This is helpful when changing out a JetPak™ or
a filter cartridge. Pressing any button resets the spa.
Option
The “Option” button is used to operate any equipment
added to spa. Follow manufacturer’s instructions.
Aux
The “Aux” button is used to operate any equipment
added to spa. Follow manufacturer’s instructions.
Mode/Prog
This button is used to switch between standard, econ-
omy, and sleep modes. Press “Mode/Prog” to select
desired mode (LCD flashes until confirmed), then press
“Cool” to confirm selection.
Standard Mode is programmed to maintain the desired
temperature. Note that the last measured spa
temperature displayed is current only when the circ
pump has been running for at least 2 minutes. The
“
STANDARD ” icon will display until the mode is
changed.
Economy Mode heats the spa to set temperature only
during filter cycles. The “ ECONOMY ” icon will display
until mode is changed.
Sleep Mode heats the spa to within 15°F of the set
temperature only during filter cycles. The “ SLEEP ” icon
will display until mode is changed.
Preset Filter Cycles
There are two filter cycles per day. The start/end times
of each cycle are programmable. To program start/end
times, continue following prompts after setting time as
instructed above, pressing “Mode/Prog” to advance to
the next setting (or to exit after the last setting). The
default filter cycles are as follows: The first filter cycle
is automatically activated at 8:00 AM and operates the
low speed of pump 1 until 10:00 AM. The LCD above
the “Time” button will light when filter 1 is running. The
second filter cycle is automatically activated at 8:00
PM and operates the low speed of pump 1 until 10:00
PM. The LCD above the “Mode/Prog” button will light
when filter 2 is running.
The low speed of pump 1 and the ozone generator (if
installed) will run during filtration. At the start of each
filter cycle, the high speed of pump 2 will run for 5
minutes.
Wiring Diagram: Limited Control System