BullFrog 2001 Portable Spas, Руководство пользователя

Страница: 15 / 42

Page 15 Bullfrog Spas Owner’s Manual
DELUXE CONTROL SYSTEM
MASTER CONTROL PAD (Fig. L)
Temp Set (80°F - 104°F)
The start-up temperature is set at 100°F. The last meas-
ured temperature is constantly displayed on the LCD.
Note that the last measured spa temperature dis-
played is current only when pump 1 (“Jets 1” )has
been running for at least 2 minutes .
Press the “Warmer” or “Cooler” button to display and ad-
just the set temperature. After three seconds, the LCD
will automatically display the last measured spa
temperature.
Jets 1
Touch the “Jets 1” button once to activate the low speed
of pump 1 and again for the high speed. Press the “Jets
1” button again to turn off pump 1. If left running, the
pump’s low speed will automatically turn off after 2
hours, and the pump’s high speed will automatically
turn off after 30 minutes. The pump’s low speed runs
when the spa is heating, when a filter cycle is activated,
or when a freezing condition is detected. If the pump’s
low speed is on under Automatic Spa Control, it can
only be deactivated by entering the Standby Mode.
Note: The Auxiliary Control Pad for “Jets 1” (optional)
activates the jets in the same manner as the Master
Control Pad. (Fig. M)
Jets 2
Touch the “Jets 2” button once to activate the low speed
of pump 2 and again for the high speed. Press the “Jets
2” button again to turn off pump 2. If left running, the
pump’s low and high speeds will automatically turn off
after 30 minutes. Note: The Auxiliary Control Pad for
“Jets 2” (optional) activates the jets in the same manner
as the Master Control Pad. (Fig. M)
Light
Press the “Light” button to turn the light on and off. If
left on, the light automatically turns off after 4 hours.
Mode
This button is used to switch between Standard, Econ-
omy, and Sleep Modes.
Standard Mode is programmed to maintain the desired
temperature. Note: the last measured spa temperature
displayed is current only when pump 1 has been run-
ning for at least 2 minutes. “
Std ” will be displayed
momentarily when you switch into standard mode.
Economy Mode heats the spa to the set temperature
only during filter cycles. “ Ecn ” will display solid when
temperature is not current, and will alternate with tem-
perature when temperature is current.
Sleep Mode heats the spa to within 20°F of the set tem-
perature only during filter cycles. “ SLP ” will display solid
when temperature is not current, and will alternate with
temperature when temperature is current.
(Figure L2) Control Pad
(Figure L1) Deluxe Control Pad
(Figure M) Auxiliary Control Pad