BullFrog 2001 Portable Spas, Руководство пользователя

Страница: 35 / 42

Page 35 Bullfrog Spas Owner’s Manual
Cleaning the Scum Line: With normal use of your spa,
oils, lotions and hairsprays will build up on the
surface of the water, sometimes leaving a scum line
around the perimeter of your spa shell. This scum line
can easily be removed with a spa SURFACE CLEANER
or its equivalent. See your authorized Bullfrog Portable
Spa Dealer for this product.
Note: Avoid using cleaning agents that will leave suds
in your spa water.
LOW-USE OR NO-USE PERIODS
At certain times of the year you may not use your spa
as often as expected. For these low-use or no-use
periods, we recommend the following:
Low-Use: If your spa is being used less than once per
month, then you may wish to lower the temperature
setting by approximately 5-10°F or put the spa in the
"Economy Mode". Lowering the temperature on your
spa will cut your cost of operation if you are not using
the spa for extended periods, however, you will need
to adjust the temperature setting approximately 15
minutes before each use to heat the spa to the
desired level.
No Use for 1-2 Weeks: If you plan to not use your spa
for one-two weeks, then we suggest that you not
make any changes in operating your spa. Substantially
reducing the water temperature (in well insulated
spas) for short periods of time has proven to increase
heating costs.
No Use for 2-6 Weeks: If you plan to not use your spa
for two-six weeks, then you may wish to lower the
temperature setting to approximately 80°F during the
No-Use period.
No Use for Over 6 Weeks: If you plan to not use your
spa for over six weeks, then it is suggested that you
winterize your spa by taking the following steps:
SPA WINTERIZATION:
1. Drain the water from the spa (see "Steps to Drain
Your Spa" under "Changing Your Spa Water" in this
Owner's Manual).
2. Drain the spa equipment. This is done by removing
the drain plug from the pump(s) and loosening all PVC
pipe unions and pump air bleed valves in the
equipment compartment.
3. Clean the spa shell (see "Spa Shell Care" in this
Owner's Manual).
4. Remove filter cartridge(s), clean filter (see "Cleaning
Your Filter" in this Owner's Manual), allow to dry, and
then store inside your garage or home.
5. Remove and properly winterize your pH Sensor
(Option on Limited Control Systems). For winterization
instructions contact your authorized Bullfrog Spa
Dealer.
6. Reattach and secure cover to the spa.