Bull NovaScale R630 E1, Руководство по установке, Страница: 115 / 146

5-5
4. Enter “public” in the [Community name] box in the [Traps] property sheet and click the [Add to list] button.
IMPORTANT:
„
To change the community name of traps to be received from the default “*” in the NEC ESMPRO
Manager site, enter the same name as the community name newly set in the NEC ESMPRO
Manager site.
„ To receive trap from NEC ESMPRO Agent at the NEC ESMPRO Manager machine, both
community names should be the same.
5.
Click the [Add...] button in [Trap destinations]. After entering the IP address of the NEC ESMPRO Manager
machine of the send destination in the [Host name, IP or IPX address] box, click the [Add] button.
IMPORTANT:
If the IP address (or host name) of the remote NEC ESMPRO Manager specified as the trap send
destination in the setup of the manager report (TCP/IP), the message warning the duplication appears.
The specification of the same NEC ESMPRO Manager causes to be reported doubly.
6. Open the [Security] property sheet and make settings as follows;
•
Add the community name entered in Step 4 to [Accepted community names].
•
Set its authority to [READ CREATE] or [READ WRITE].
•
Select [Accept SNMP packets from any host.]
IMPORTANT:
„ If you entered any community name other than “public” in Step 4, add that name to “Accepted
community names.”
„
Unless you set the acceptable community’s authority to “READ CREATE” or “READ WRITE,”
you cannot perform monitoring from NEC ESMPRO Manager.
Setup of receiving SNMP packets from specific hosts only
Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP addresses of the
servers to install Agent, and the loop-back address (127.0.0.1).
Setup of receiving SNMP packets from specific communities only
Change the name of the community receiving SNMP packets from the default “public” to any name.
IMPORTANT:
„
If the community name is changed, the community of NEC ESMPRO Agent is changed and
registered by starting from [Control Panel]. To change the community to another and register
it, use the [SNMP Community] list box in the [General] tab.
„
To allow NEC ESMPRO Agent to receive SNMP packets sent from NEC ESMPRO Manager,
set the send community name in NEC ESMPRO Manager to be the same as that accepted by
the SNMP Service in NEC ESMPRO Agent.
7. Terminate the network setup.
IMPORTANT:
„ During OS installation, if the SNMP service is added to the system after applying the service
package, apply it again. If not, the SNMP service may not operate properly, and this can cause
the improper operation of NEC ESMPRO Agent.
„ The SNMP Service is required for operating NEC ESMPRO Agent. If the SNMP Service is
deleted after the installation of NEC ESMPRO Agent, install the SNMP Service and then
reinstall NEC ESMPRO Agent.
„
Some software products provided by other vendors use the SNMP Service. If the SNMP Service
and NEC ESMPRO Agent are installed in the system in which such software as above is
installed, it may be impossible to start NEC ESMPRO Agent services. If so, delete the SNMP
Service once and install the service again. After which, reinstall NEC ESMPRO Agent and the
other vendor's software.