Buchi Nano B-90, Руководство по эксплуатации

Страница: 61 / 104

5 Putting into operation
61
B-90 Operation Manual, Version B
1
3
2
a
Outlet of the Nano Spray Dryer B-90
c
Outlet of the Inert Loop B-295
b
Outlet of the Dehumidifier B-296
Installation steps
1. Disconnect the power cord from the mains and depressurize all system parts.
2. Put the holder of the adsorption column
e
on the Inert Loop B-295 and fix it with the adhesive
tape.
3. Attach the adsorption column with the installed sieve bag and the humidity sensor
a
at the
holder
e
.
4. Connect the inlet tube
d
of the adsorption column to “GAS OUT” at the Nano Spray Dryer
Advanced B-90 (see section 4.10; connector
e
). Use hose clamps to fix the tubing.
5. Connect the adsorption unit outlet tube
c
from the column outlet at the humidity sensor to the
Inert Loop B-295 inlet. Use hose clamps to fix the tubing.
6. Connect the outlet of the Inert Loop B-295 to the inlet of the Aspirator (see section 5.6.1; gas
inlet
a
). Use hose clamps to fix the tubing.
7. Connect the gas outlet of the Aspirator to the GAS IN at the Nano Spray Dryer Advanced B-90.
Use hose clamps to fix the tubing.
8. Plug in the Inert Loop B-295 communication cable (see section 5.7; cable
a
) into the external
electronic box b. Secure the electronic box with double-faced adhesive tape at the housing.
9. Plug the humidity sensor cable into the external electronic box
b
.
10. Plug the communication cable of the electronic box into the Nano Spray Dryer B-90 (see section
4.10; socket
c
).
11. Connect cooling water or a recirculating water chiller to the double jacket of the adsorption
column (see section 5.7.2; connectors
f
) if passive cooling is not sufficient.
12. Connect the inlet filter to the gas inlet of the Aspirator. Use a hose clamp to fix the tubing.
13. Connect the power cord to the mains. The device can now be switched on.