27
2.6 Installation with Ceiling Mount Bracket (391715/391716/391717 Models)
①
Remove the ceiling tile from the ceiling and cut a
hole whose diameter is 30~40mm on the ceiling tile
to pass the wire(s) and cable(s) through to the upside
of the ceiling. (In case of the wiring and cabling
through the mounting surface only) Then prepare
the ceiling mount bracket. Pull the wire(s) for the
system as below. (Anchor Bolt 3/8"
×
70)
②
Pull the wire(s) and cable(s) for the system as below.
Wire the cable(s) to the ports. Insert the mounting
hooks into the holes on the surface of the main body
and turn the main body. Assemble the main both with
the camera mount adaptor with the 3 screws. (Machine
M5
×
15)
③
Screw the dome cover to the main body and remove
the protection vinyl from the dome cover.
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
To adjust the installation height from the mounting surface, the pipe and coupler should be needed between the surface
mount part of the ceiling mount bracket and the camera mount part of the ceiling mount bracket. Note that they are not
supplied by the manufacturer.