391695 / 391696 / 391715 / 391716 / 391717
22
2.3 Installation with Surface Mount Bracket (391695 Model)
①
Remove the ceiling tile from the ceiling and
cut a hole whose diameter is 30~40mm on
the ceiling tile to pass the wires and cables
through to the upside of the ceiling. (In case
of wiring and cabling through the ceiling tile
only)
②
Prepare the surface mount bracket. Pull the wires and cables
for the system as below. Attach the surface mount bracket to
the mounting surface. (Tapping M4
×
25)
③
Connect the wires and cables to the ports
and install the main body. (Machine M3
×
8)
④
Align the dome cover stud with the dome cover assembly
stud and slightly push the dome cover to the ceiling. Turn the
dome cover clockwise and screw on the dome cover lock-up
screw. Then remove the protection vinyl from the dome cover.
(Machine M3
×
6)
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
When the pipe hole for wiring and cabling on side of the Surface Mount Bracket is not used, make sure that the hole is
properly sealed with the supplied Hole Plug.
