Brunswick GS-X Pinsetter, Руководство по эксплуатации

Страница: 59 / 62

GS-X Pinsetter w/Advanced (CE) Guarding Operation Manual 59
PROBLEM CAUSE CORRECTIVE ACTION
21. Table does not set pins after
second ball or table is not full.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Pin jam in distributor.
Bent pin distributor guide tabs.
Faulty pin holder solenoid.
Table not adjusted to proper height.
Broken pin station on distributor.
Not enough pins in machine.
Broken pin holder electrical
connections.
Faulty electronics.
Faulty pin holder switch or switch
actuator.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Remove jam.
Adjust as required.
Replace solenoid as required.
Adjust table.
Replace as required.
Be certain 22 pins are in machine.
Repair connections.
Change the Nexgen CPU PCB.
Repair pin holder switch or switch
actuator.
22. Table is full but does not lower. 1.
2.
3.
4.
5.
6.
Faulty pinholder microswitches.
CPU fuse Is blown (Nexgen).
Faulty Nexgen CPU or H.V. PCB .
Pin holder switch actuator sticking.
Pin detector plate stuck up.
Pin holder out of postion detector
plate hangs up.
1.
2.
3.
4.
5.
6.
Adjust or replace microswitches.
Replace fuse
Replace faulty box or PCB.
Repair
Check clearance between plate
and pin holders.
Adjust pin holder assembly.
23. Pins wobble or fall over while being
set.
1.
2.
3.
4.
5.
Pin holders not plumb.
Table not adjusted for proper
height.
Table is not completely level.
Faulty table spring.
Pin bottoms are worn.
1.
2.
3.
4.
5.
Make sure pin holders are vertical.
Adjust table height.
Level table.
Replace spring.
Scrap or repair worn pins.