SET-UP
sbl2006-002-104_a
sbl2006-002-102_a
Slide chamfered end between bezel and cluster,
in line with each side locking tab, pushing out
smoothly while lifting out bezel; repeat procedure
with lower locking tab and then, gently lift bezel
upward, out of its upper locking tabs.
Remove and keep both screws retaining
instrument cluster. Unplug and set cluster aside
for now.
sbl2006-002-101_b
NOTE:
At 2 places at bottom of cluster, rubber
shims [1] are folded on body for a tight fit; care
should be taken not to lose those shims so they
are reused when reinstalling cluster.
F19L236
On some models, it is required to cut the locking
tie retaining support plate to front storage cover
or to mirror.
Install rear view mirrors on both sides.
NOTE:
Install left and right mirrors so that
inscription “OBJECTS IN MIRROR ARE CLOSER
THAN THEY APPEAR” is in upright position.
Secure each mirror with:
– 2 M8 x 120 hexagonal bolts (P/N 230 062 060)
and
– 2 M8 stainless steel flat washers
(P/N 234 062 500), all from predelivery
kit .
Torque to 5 N•m (44 lbf•
in
).
NOTE:
To ensure a correct installation, torque rear
bolts (closest to mirror) before front ones.
Reconnect instrument cluster and secure back in
place using same screws.
Torque screws to a
MAXIMUM
of 1.5 N•m
(13 lbf•
in
).
— Models
WITH
the cluster bezel already
installed —
Reinstall instrument cluster bezel simply by
pushing it in so it snaps back in place.
— Models
WITHOUT
the cluster bezel already
installed —
Bezel is in mirror bag; install instrument cluster
bezel simply by pushing it in so it snaps in place.
Model(s):
GTI SE
(International Only)
Pull out temporary plastic fasteners, 2 retaining
pod and 2 retaining glove box.
Set glove box aside.
Align mirror support inside pod to install each side
mirror.
Predelivery
2008-1
9 / 29
