FINAL PREPARATION
1
2
3
F18F076
To adjust throttle cable, loosen jam nut [2] then
turn adjustment nut [1] as necessary.
WARNING
Make sure idle speed screw contacts throttle
cam when throttle lever is fully released at
handlebar.
CAUTION:
Never attempt to adjust idle speed
through throttle body tamper proof screw. If
so, it would impair idle speed stability. Besides,
no adjustment could be performed by dealer
nor factory to correct idle speed. Throttle body
would need to be replaced. Also take into
account that it might change engine emission
level and engine might not meet EPA/CARB
requirements.
For more informations on throttle cable
adjustment, refer to appropriate Sea-Doo
SHOP
MANUAL
.
FINAL INSPECTION
General Instructions
Make sure that tool kit and fire extinguisher are
properly secured at their proper location.
Complete
PREDELIVERY CHECK LIST
following
all instructions.
Test ride watercraft.
Decal Protective Films
Protective film on all decals must be removed.
Slowly peel off protective films.
Cleaning the Watercraft
Clean watercraft.
CAUTION:
Clean apparent fiberglass and plastic
parts with a clean cloth and soapy water or
isopropyl alcohol. Never use strong detergent,
degreasing agent, paint thinner, acetone, etc.
Do not apply isopropyl alcohol directly on
decals.
Accessories
On some models, accessories, such as wakeboard
rack, GPS (Global Positioning System), etc., must
be installed prior to delivering vehicle. Refer to
appropriate
OPERATOR'S MANUAL
for complete
installation procedure.
NOTE:
Procedures must be explained to
purchaser.
Delivery to Purchaser
General Instructions
Where possible, give a brief demo ride and explain
watercraft operation.
Explain, complete and return WARRANTY
REGISTRATION CARD (legal requirement).
Purchaser must sign
PREDELIVERY CHECK LIST
.
Give to purchaser:
– Operator's guide
– Safety DVD
– Copy of the
PREDELIVERY CHECK LIST
Fuel System
Explain to purchaser that it might be necessary to
remove and install safety lanyard 2 or 3 times to
initially feed fuel system.
Handlebar Tag
A tag is tied to handlebar. Leave it there until
delivery and make sure purchaser reads it.
Break-In Period
Explain to purchaser that with Sea-Doo watercraft
powered by Rotax
®
engines, a break-in period of
10 hours is required before continuous operation
at full throttle. To achieve a good break-in, vary
engine speed every few minutes with brief wide
open throttle accelerations of up to 15 seconds.
Continued wide open throttle runs and prolonged
cruising without speed variations should be
avoided, this can cause engine damage during
break-in period.
NOTE:
Never add oil in fuel tank during break-in
period.
24 / 29
2008-1
Predelivery
