SET-UP
Secure each mirror with:
– 2 M8 x 120 socket head bolts and
– 2 M8 stainless steel flat washers , all from
predelivery kit .
Insert rearward screw through mirror support hole
and in mirror and tighten manually.
NOTE:
Install left and right mirror so that the
inscription “OBJECTS IN MIRROR ARE CLOSER
THAN THEY APPEAR” is in upright position.
Insert forward screw and tighten manually.
Without touching mirrors, complete tightening
both mirrors in the following sequence:
– left rear screw then right rear;
– left front screw then right front.
Torque to 5 N•m (44 lbf•
in
).
Reinstall pod in place and insert 6 new rivets
(P/N 293 150 123) (from predelivery kit ) in their
respective holes; do not pop yet.
Reinstall box in place and insert 4 new rivets
(P/N 293 150 123) (from predelivery kit ) in their
respective holes; do not pop yet.
Secure mirror support using M10 stainless steel
flat washer (P/N 234 002 600) and M10 x 40 socket
head screw (P/N 205 004 060) from predelivery
kit ; start screwing only to grab threads; do not
torque yet.
Pop all rivets, box's and pod's and then, tighten
mirror support screw. Torque to 8 N•m (71 lbf•
in
).
Model(s): GTI std and GTI std R International
Only
Insert 6 new rivets (from predelivery kit ) in their
respective holes, in pod; do not pop yet.
Insert 4 new rivets (from predelivery kit ) in their
respective holes, in box; do not pop yet.
Now that all rivets are in position, pop them from
left to right and front to rear.
Reverse Handle
Model(s): GTI std, GTI std R, GTI SE
International Only
sbl2006-002-105_a
Install reverse handle (from glove box) using guide
[1] (P/N 268 000 023), pop rivet (P/N 204 000 081),
and 2 Phillips
†
M5 x 12 (P/N 250 000 319) screws
from predelivery kit .
Handlebar Assembly / Handlebar
Cover
Model(s): International models except X
– Handlebar assembly is located on the deck
at the rear of vehicle or
D
in the engine
compartment for the RXP X
A
. To install it,
refer to
HANDLEBAR ASSEMBLY
further in this
bulletin.
Model(s): North American models except X
– Upper handlebar cover with padding is located
inside front luggage compartment, underneath
storage box. To install it, follow this procedure:
† Phillips is a registered trademark of Phillips Screw Co.
10 / 29
2008-1
Predelivery
