UNCRATING
UNCRATING
Crate Cover
Model(s): All
2
2
1
F00A2A6
Carefully lay crate on its bottom.
CAUTION:
Allowing crate to drop may cause
serious damage to watercraft.
Remove all screws [1] retaining crate cover to
crate base.
NOTE:
Screws that are used are Robertson
†
#2
type that require the use of an appropriate bit
(Scrulox #2 from Snap-on
††
Tools or ECAR.1 from
Facom
†††
Tools).
Assisted by another person, lift up crate cover [2].
NOTE:
Do not tip cover toward front or back of
watercraft. Raise cover vertically [2] from both
ends at the same time.
Remove watercraft protective bag.
Remove parts from watercraft's storage
compartments and from crate.
Lifting the Watercraft
Model(s): All
Cut strapping at watercraft front eyelet.
Release shipping bracket at rear of watercraft from
crate base.
Lift watercraft using appropriate lift kit and install
it on a proper support.
Engine Foam Protector
Model(s): International
Remove seat(s).
1
F18P016
Remove the foam protector [1] supporting engine.
Shipping Bracket
Model(s): All
1
3
2
F08A066
Remove shipping bracket [1] from venturi.
Discard shipping bracket and hexagonal bolts [2].
Keep the flat washers [3] located between bracket
and pump.
† Robertson is a registered trademark of Robertson Inc.
†† Snap-on is a trademark of Snap-on Inc.
††† FACOM is a brand of International tools Group, subsidiary of FIMALAC.
4 / 29
2008-1
Predelivery
