Check Bulb Blinders Alignment:
9)
With nothing on the belt, make sure
each lane has been started (use
“start/stop job” option on main kiosk.
10)
On each drone control panel select
“Menu”.
11)
Select “Factory Setup”
12)
Select “Bulb Setup”
13)
Press each circle at the right of the
image once to turn each circle green.
This will turn the bulbs on in the
selected lane. (Figure 4)
14)
Wait 2 minutes. All temperatures should
be similar in value, all should be less
than 290 degrees.
15)
Press each green circle again to turn
them all off.
16)
Select the next zone from the drop-down
“Belt” list at the top-left.
17)
Repeat steps 5-8 until all zones have
been tested.
If any of the lanes show high temperatures
(above 290 degrees), push the bulb rack as far as
it can go in its track.
If temperatures continue to be high, contact
Brown Manufacturing for instructions on
adjusting the camera bulb blinders.
Check Camera Alignment:
During normal operation of the machine, a series
of dark lines will show up on each camera
image. These lines will be slightly curved, but
should overall run straight left-right across the
image. If a camera is twisted in its socket, the
lines will tend to run “downhill” from one side
of the screen to the other. To fix this issue:
1)
Remove camera access plate (Figure 6)
2)
Loosen camera holder screws a very
small amount (1/2 turn each screw)
3)
Gently twist the camera in its socket
until the picture on the screen is correct.
4)
Tighten camera holder screws FINGER
TIGHT ONLY. Make sure the screws
press only on the edge of the main
circuit board on the camera.
5)
Make sure that as objects travel through
the lane, they first appear at the bottom
of the image, and travel towards the top.
This ensures the camera has not been
rotated 180
º
.
Clean Belt Movement Sensor:
The belt movement detection system is located
on the left-hand side of the take-up roller (Figure
7). Remove the side cover guard to access the
mechanism.
Clean any dust/lint that may have built up on the
disk/sensor system.
TAKE-UP
ROLLER
PULSE DISK
PULSE
SENSOR
Figure 7: Belt Movement Sensor System
