Broderson IC-200-2H, Руководство по эксплуатации и обслуживанию

Страница: 70 / 74

3-26
ENGINE MAINTENANCE:
Refer to the engine manual for engine maintenance.
AIR CLEANER SERVICE:
Gas or Dual Fuel Engine:
Clean out the dust cup every 50 hours. Loosen the clamps around the cup and housing and
remove the cup. Dump dust out of cup. Clean g asket and sealing surfaces with a dam p
cloth. Replace cup gasket if it shows signs of damage. Replace cup w ith arrows pointing up
and tighten clamp.
Clean the intake cap screen every 50 hours, and perform a thorough inspection of the air in-
take pipes and joints.
Clean the filter element every 250 hours or every 3 months, whichever comes sooner and re-
place the element every 500 hours or 6 months. Remove and clean the dust cup and gasket,
and the intake cap. Remove the wing nut on t he element and g ently remove the element.
Bumping the element during removal may cause dirt to fall into the clean air tube. Clean the
inside of the housing carefully with a damp cloth. To clean the element, use a compressed air
blower nozzle with less than 100 PSI and blow air from the inside of the element. Shake dust
off of the outside of the element. Make sure the gaskets and element fit properly and reas-
semble, being careful not to allow any dust into the intake pipe.
Do not remove an element just for inspection. This may do more harm than good. You can-
not judge the element condition by its appearance. If you think the filter may need service,
remove it and replace or clean it before reassembling air cleaner.
Conditions where more dirt than usual is in t he air, especially soot, will make more frequent
service necessary. If there is a sig nificant amount of dust in the dust cup when it is cleaned
every 50 hours, clean the element every 100 hours and replace it every 200 hours--or more
frequently in extremely dusty conditions. Excessive exhaust smoke or loss of power may indi-
cate a plugged filter.
Diesel Engine:
Check the air filter restriction indicator daily with the engine running. If the indicator is in t he
“Replace” zone, replace the primary and secondary filter. If the filter has not been changed
for over 1000 hours, replace the filter regardless of the restriction indicator reading.
Courtesy of Crane.Market