BC4000 Series RAID Controllers
User Manual
02/13/06
B ro ad c om C o r p or at i on
Page 18
Installing and Cabling BC4000 Hardware
Document
BC4000-UM100-R
To install a hard disk:
1.
Connect the SATA cable to the BC4000 Series RAID controller as shown on
Figure 5
.
Figure 5: BC4000 Series Cable Connection Between Controller and Hard Disk
The SATA cable has a connector at each end. Either connector can be plugged into the drive or controller.
It does not matter which port on the controller the SATA cables are plugged into.
2.
Install hard disk drive(s) into the chassis.
3.
Connect power to all hard disk drives.
4.
Reconnect any peripherals or cables that were previously disconnected.
5.
Replace the cover of the computer.
Note:
Use either the standard Molex connector or, if available on the power supply, the new SATA
power connector. Do not use both.