INSTALLER’S GUIDE
Page 14
Figure 10 Closure Plate for Wall Mounting
The closure plate must be fitted and sealed to
the hearth and fireplace opening using a
suitable heat resistant material. If necessary
cut the closure plate but make sure that it
overlaps the fireplace opening sufficiently to
allow satisfactory sealing.
3.4.2
Wall mounting
See figure 10.
The closure plate must be fitted and sealed to
the hearth and fireplace opening using a
suitable heat resistant material.
If necessary cut the closure plate but make
sure that it overlaps the fireplace opening
sufficiently to allow satisfactory sealing.
The bottom of the appliance must be at least
100mm above any carpet or other floor
covering. To achieve this, the bottom of the
flue spigot opening must be at least 565mm
above the finished floor covering.
3.4.3
Check the flue pull with
closure plate fitted by applying a
lighted match or smoke match to
the flue spigot opening in the
closure plate and observe the
smoke. If there is a definite flow
continue with the installation. If
not check the fitting of the closure
plate. The fireplace flue pull check
described in section 3.2 should
have confirmed that the fireplace
itself is satisfactory.
Figure 9 Closure Plate for Hearth
Mounting
