INSTALLER’S GUIDE
Page 12
Figure 6. Window removal
Figure 5. Outer case removal
Figure 4. Window surround removal
3.3
Appliance Preparation
3.3.1.
Stand the fire upright.
3.3.2
Remove two transit screws
from the upper back panel. See
figure 3A.
3.3.3.
Remove the control knob by
pulling clear of the gas tap spindle.
3.3.4.
Remove the control bezel by
unscrewing two screws. See figure
5.
3.3.5.
Detach the outer case by
removing the screws at the case sides. See
figure 5.
Spring the bottom corners of the case
outwards and pull the bottom of the case
forwards to clear the fixing brackets. Lift
the case upward and forwards to clear the
top location. See figure 5.
3.3.6.
Two screws as shown in figure 4
secure the front fascia of the case. These
screws have been tightened to avoid
damage to the case during transit. These
screws must be slackened to enable the
customer to remove this section of the
case. Slacken the two screws, detach the
window surround by sliding it upwards and
then swinging the bottom forwards. Lift and
store carefully.
3.3.7.
Remove the window unit by turning the
screws each side of the window frame ¼ turn
anticlockwise and lifting the unit clear. See
figure 6.
The flattened end of the smoke match
tube can act as a screwdriver.
3.3.8.
Remove the coal pack from the firebox
and keep it safe.
