Briot emotion, Руководство по эксплуатации

Страница: 50 / 210

Using your Edger... General principles of use
3-49
3.2.4.4 N
ORMAL EDGING CYCLE SEQUENCE
Once you have started the edging cycle, the following steps follow automatically:
Flow chart 3-2: Edging cycle sequence
Note: Selecting Manual finishing (beveling, grooving) leads to a modification in the standard
edging cycle sequence.
3.2.4.5 I
MPORTANT NOTES
3.2.4.5.1 W
HEN JOB DATA ARE RECEIVED
> If the job provides the edging data, they are displayed automatically.
Example: If the job finishing is a bevel, the finishing displayed will automatically be Bevel.
>
If the job provides no edging data, the characteristics configured by default (see Configuration of finishing
parameters default values, chapter 4) are displayed automatically.
Example: If the default finishing is Bevel and the type is Auto, the displayed finishing will be Bevel
and the sub-finishing will be Bevel Auto.
> If the job specifies data which have been excluded from the edger configuration, an « Incompatible edger
configuration » message is displayed (see , chapter 5).
> If you modify the job data before starting to edge one of the lenses, the new characteristics will be
memorised automatically and applied to the two lenses.
Caution! Check the parameter values of the two lenses.
> The lens characteristics ( material and type ) determine the types of finishing available.
Example: A mineral lens cannot be drilled. Drilling finishing is therefore not available in the finishings
pull-down menu when Mineral lens material is selected.
3.2.4.5.2 D
URING EDGING OF THE SECOND LENS

Always check that the preselected type of finishing is the finishing that you wish to apply.
In fact, the finishing selected for the first lens is automatically memorised and preselected for the
following lens (see “Edging several lenses identically”, page 77 and see “Edging the left lens with
different parameters from those of the right lens”, page 76).

Check the parameter values.
e motion
Automatic closing of the lens clamp shaft
Lens roughing
Lens finishing (Rimless or Bevel)
Lens chamfering (if selected)
Lens polishing (if selected)
Lens safety-beveling (if selected)
Lens grooving (if selected)
Lens drilling (if selected)