Briot emotion, Руководство по эксплуатации

Страница: 188 / 210

Maintenance... Messages
5-187
0x12 Incompatible edger
configuration.
Drilling finishing not
allowed. The job you have loaded calls
for Drilling finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Drilling finishing.
Load the job again.
0x13 Incompatible edger
configuration.
Grooving/drilling finishing
not allowed. The job you have loaded calls
for Grooving/Drilling finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Grooving/Drilling
finishing.
Load the job again.
0x14 Incompatible edger
configuration.
Automatic Bevel sub-
finishing not allowed. The job you have loaded calls
for Automatic Bevel sub-
finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Automatic bevel sub-
finishing.
Load the job again.
0x15 Incompatible edger
configuration.
Bevel curve sub-finishing
not allowed. The job you have loaded calls
for Bevel curve sub-finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Bevel curve sub-finishing.
Load the job again.
0x16 Incompatible edger
configuration.
Bevel distance (in mm) sub-
finishing not allowed. The job you have loaded calls
for Bevel distance (in mm) sub-
finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Bevel distance (in mm)
sub-finishing.
Load the job again.
0x17 Incompatible edger
configuration.
Percent bevel sub-finishing
not allowed. The job you have loaded calls
for Percent bevel sub-finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Percent bevel sub-
finishing.
Load the job again.
0x18 Incompatible edger
configuration.
Manual bevel sub-finishing
not allowed. The job you have loaded calls
for Manual bevel sub-finishing.
In the personalisation menus,
you have excluded this
parameter.
Therefore the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, change the
personalisation of the pull-down
menus.
Select Manual bevel sub-
finishing.
Load the job again.
# Message
Condition(s) for
display
Action(s)