15
Installation
Phenolic Privacy Restroom Partitions, Floor-to-Ceiling — Series 700, — 69", 72" & 69"/72" Tall
Bradley •
HDWC-INSTR-045 Rev. A: ECO 20-14-002S
6/25/2021
6
Pilasters and Panels with Stirrup Brackets – Single Panel (Standard)
Pilasters located at walls should be mounted first. Start at one end and install a panel, then a pilaster. Continue alternating until
installation is complete. When installing in an alcove or in-corner, use an alcove bracket to secure the pilaster to the panel.
Pilasters at Wall
Pilasters with Panels
(Single Panel)
Check to make sure the pilasters are plumb and level to each other. The pilaster height can be adjusted with the leveling screw that
was placed at the bottom of the pilaster (see page 11 for attaching leveling screw).
When installing pilasters at walls, the gaps range
from 1/2" to 1-1/4" (13 to 32). Refer to your submittal
drawing for your gap sizes.
Refer to your submittal drawing and leave the appropriate
gaps. Standard gap is 1" (25) between the panel and wall
and 1/2" (13) between the panel and pilaster.
Spacer 6" (152) for 72" Tall Panels (72" Tall Option)
Spacer 9" (229) for 69" Tall Panels / ADA Stall (69" Tall Option)
Slide a shoe onto the top of the pilaster and use
a piece of tape to keep the shoe positioned about
5" (127) from the end . Make sure the shoe mounting
hole is towards the bottom .
A
Place the pilaster into the shoe secured to the floor
while at the same time placing it within the wall
brackets .
B
Using the bracket as a template, drill Ø1/4" holes
through the pilaster at each pilaster bracket hole .
Secure the pilaster to the bracket using the
#10-24 x 1/2" barrel nuts and #10-24 x 3/4" shoulder
screws provided .
C
Place the panel on the spacer and insert the panel into the
wall brackets .
A
Slide a shoe onto the top pilaster and use a piece of tape to
keep the shoe positioned about 5" (127) from the end . Make
sure the shoe mounting hole is towards the bottom .
B
Place the pilaster into the shoe secured to the floor while at
the same time placing the brackets around the panel .
C
Using the bracket as a template, drill Ø1/4" holes through
the panel at each panel bracket hole . Secure the panel to
the bracket using the #10-24 x 1/2" barrel nuts and
#10-24 x 1/2" shoulder screws provided .
D
Refer to the
submittal drawing
for the correct
orientation
of the pilaster .
