Bovie Aaron 1250, Руководство по обслуживанию, Страница: 52 / 68

CLEANING THE UNIT
After each use, clean the unit.
WARNING
Electric Shock Hazard Always turn off and unplug the generator before cleaning.
NOTICE
Do not clean the generator with abrasive cleaning or disinfectant compounds, solvents, or other
materials that could scratch the panels or damage the generator.
1. Turn off the generator, and unplug the power cord from the wall outlet.
2. Thoroughly wipe all surfaces of the generator and power cord with a mild cleaning solution or disinfectant and a
damp cloth. Follow the procedures approved by your institution or use a validated infection control procedure.
Do not allow fluids to enter the chassis. Do not sterilize the generator.
PERFORMING PERIODIC INSPECTION
Every six months, visually inspect the Aaron 1250 for signs of wear or damage. In particular, look for any of the
following problems:
• Damage to the power cord
• Damage to the power cable receptacle
• Obvious damage to the unit
• Damage to any receptacle
• Accumulation of lint or debris in or around the unit.
REPLACING FUSES
Fuses for the unit reside directly below the Power Cable Receptacle on the rear of the unit.
To replace the fuses, follow this procedure:
1. Unplug the power cord from the wall outlet.
2. Remove the power cord from the Power Cable Receptacle on the rear panel.
3. To release the fuse drawer, insert a small flathead screwdriver into the slot on
the drawer below the power cord receptacle. Then, slide the drawer out.
4. Remove the two fuses and replace them with new fuses with the same values.
5. Insert the fuse holder into the Power Cable Receptacle.
Use the following fuses:
52 Bovie / Aaron Medical
110 - 120 V 220 - 240 V
VAC 250 250
AMPS 5.0 A 3.15 A
Type Slow Blow Slow Blow
Size 5 x 20 mm 5 x 20 mm
Fuse Holder