Bosch VCD Series, Руководство по установке

Страница: 142 / 162

142 en | Configuring the HD Conference Dome HD Conference Dome
F.01U.265.806 | 1.0 | 2012.03 Installation Manual Bosch Security Systems, Inc.
code. If you wish to send SNMP traps, enter the IP addresses of
one or two required target devices here.
If you select On for the SNMP parameter and do not enter an
SNMP host address, the HD Conference Dome does not send
them automatically, but only replies to SNMP requests. If you
enter one or two SNMP host addresses, SNMP traps are sent
automatically. Select Off to deactivate the SNMP function.
1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP
addresses of one or two required target units here.
SNMP traps
You can select which traps are to be sent.
1. Click Select . A list is opened.
2. Click the checkboxes to select the required traps. All the
checked traps will be sent.
3. Click Set to accept the selection.
Authentication
If a RADIUS server is employed in the network for managing
access rights, authentication must be activated here to allow
communication with the unit. The RADIUS server must also
contain the corresponding data.
To configure the unit, you must connect the HD Conference
Dome directly to a computer using a network cable. This is
because communication via the network is not enabled until the
Identity and Password parameters have been set and
successfully authenticated.
Identity
Enter the name that the RADIUS server is to use for identifying
the HD Conference Dome.
Password
Enter the password that is stored in the RADIUS server.