Bosch VCD Series, Руководство по установке

Страница: 83 / 162

HD Conference Dome Configuring the HD Conference Dome | en 83
Bosch Security Systems, Inc. Installation Manual F.01U.265.806 | 1.0 | 2012.03
same time. If necessary, you can synchronize the unit with your
computer's system settings.

Click the Sync to PC button to copy your computer's
system time to the HD Conference Dome.
Time server IP address
The HD Conference Dome can receive the time signal from a
time server using various time server protocols, and then use it
to set the internal clock. The unit polls the time signal
automatically once every minute.

Enter the IP address of a time server here.
Time server type
Select the protocol that is supported by the selected time
server. Preferably, you should select the SNTP server as the
protocol. This supports a high level of accuracy and is required
for special applications and subsequent function extensions.
Select Time server for a time server that works with the
protocol RFC 868.
12.3 Basic Mode: Network
The settings on this page are used to integrate the HD
Conference Dome into an existing network.
Some changes only take effect after the unit is rebooted. In this
case, the Set button changes to Set and Reboot .
1. Make the desired changes.
2. Click the Set and Reboot button. The HD Conference
Dome is rebooted and the changed settings are activated.
CAUTION!
If you change the IP address, subnet mask or gateway address,
the HD Conference Dome is only available under the new
addresses after the reboot.