Operating Manual
Universal Flow Computer UR06
Bopp & Reuther
A-EN-08728-URRev.B
Subject to changes
Page 35 of 55
Messtechnik GmbH
17.4.2 TAG number
A measuring point number (TAG) can be entered. This is shown in the header of the display. If no text
is entered, the header is not displayed.
Range:
15 alphanumerical digits
17.4.3 Order number
Input of the order number.
Range:
15 alphanumerical digits
17.4.4 Customer
Input of the customer’s name.
Range:
15 alphanumerical digits
17.4.5 Text 1 … 6
6 lines of text can be entered. These are for information purposes only and do not have any further
functions. The serial number of the allocated transmitters can, e.g., be entered here.
Range:
15 alphanumerical digits
17.5 Display
The display can be freely configured within broad limits. All the measuring values and relevant
calculation values can be displayed. The format and unit can be selected. Several values can be
compiled as pages; it is then possible to leaf through the pages.
17.5.1 Counters frame
A frame can be shown to specifically indicate the decimal places for counters.
123456.789 m3
Selection:
No
, Yes
17.5.2 Line number
Assignment of list values to a line in the display. If 0 is entered, the value is not displayed. If the same
line number is assigned to several values, they are displayed alternately. The available display
parameters are listed in the appendix. The list provides all the possible display parameters, but the
currently available values depend on the configuration of the universal flow computer.
17.5.3 Decimal places
Selection of the display format
17.5.4 Units
Various units can be selected for the display (see appendix). The selected unit does not influence the
calculations. The internal calculation is always in basic units. Conversion only takes place for display
purposes. The units can be selected for the parameters energy, mass, volume, pressure, temperature,
density and time. The units for power, mass and volume flow rate are derived from the units for
energy, mass, volume and time, e.g. mass [kg] and time [min] equals mass flow rate [kg/min].
17.5.5 Text
A standard text in the set language is stored for each value that can be displayed. The standard text
can be replaced by a freely selectable one for the most important values, e.g. “V15 fuel (gas)” can be
displayed instead of “standard volume 1”.
UR06 UR06
Standard volume 1
V15 fuel (gas)
001234567.5 m3
001234567.5 m3
Volume 1
Vt fuel (gas)
000983382.4 m3
000983382.4 m3
