Bomag BW 100 AC-4, Руководство по эксплуатации

Страница: 24 / 126

Safety regulations
BOMAG 24 BW 100/120/125 AD-4/AC-4
Only genuine BOMAG hydraulic hoses ensure
that the correct type of hose (pressure range) is
used at the right place.
Working on the engine
Shut the engine down before opening the engine
compartment hood.
Drain the engine oil at operating temperature -
danger of scalding!
Wipe off spilled oil, catch running out oil and dis-
pose of environmentally.
Store used filters and other oily materials in a sep-
arate, specially marked container and dispose of
environmentally.
Do not leave any tools or other objects, which
could cause damage, in the engine compartment.
Check and change the coolant only when the en-
gine is cold.
Catch the coolant and dispose of environmentally.
Working on electrical equipment
Before working on electrical equipment disconnect
the battery and cover it with insulating material.
Do not use any fuses with higher Ampere ratings
and do not repair fuses with a piece of wire. Fire
hazard!
Always disconnect the battery before starting to
weld on the machine.
Working on the battery
When working on the battery do not smoke, no
open flames!.
Do not let your hands or clothes come in contact
with acid. In case of injuries caused by acid, flush
off with clear water and consult a doctor.
Metal objects (e.g. tools, rings, wrist watches)
must not contact the battery poles - danger of
short circuit and burns!
When recharging maintenance free batteries re-
move the plugs to avoid the accumulation of explo-
sive gases.
When using an external battery to start the ma-
chine follow the respective instructions.
Dispose of old batteries environmentally.
Switch the charging current off before removing
the charge clamps.
Ensure good ventilation, especially when charging
the battery in a closed room.
Working on the fuel system
Do not inhale fuel fumes.
No open fire, do not smoke, do not spill any fuel.
Catch running out fuel, do not let it seep into the
ground and dispose of environmentally.
Working on wheels and tires
Explosion-like bursting of tires and parts of rims
and tires can cause severe or even deadly injuries.
You should only assemble tires if you have the
necessary experience and with the proper equip-
ment. If necessary have the tires mounted by a
specialised workshop.
Ensure correct tire pressure and do not exceed the
highest specified pressure.
Check tires and wheels every day for pressure
drop, cuts, bulges, damaged rims, missing wheel
studs and nuts. Do not drive with damaged tires or
wheels.
Non-sticking emulsions for tires must only be
made up of a mix of water and a concentrated anti-
stick agent according to the instructions of the
manufacturer. Observe the regulations for the pro-
tection of the environment.
Cleaning
Do not clean the machine while the engine is run-
ning.
Do not use gasoline or other combustible sub-
stances for cleaning purposes.
When using steam cleaning equipment do not
subject electrical components and insulating ma-
terials to the direct water jet, but cover them be-
forehand.
l
Do not guide the water jet into the exhaust or
into the air filter.
After maintenance work
Reinstall all protective devices after completing
the maintenance work.
Repair
Mark a defective machine by attaching a warning
tag to the steering wheel.
Repair work must only be performed by qualified
and authorized persons. Use our repair instruc-
tions for this work.