Blue Bird Q - BUS, Руководство пользователя

Страница: 14 / 73

13
F. Use rubber grommets whenever wires must pass through holes.
G. Cover all full time hot or accessory and ignition hot wires with approved loom.
H. Avoid routing wires in contact with fuel lines or plastic components.
6. Always be sure ground straps are replaced when any work is done on engine components. The
alternator must have at least a six (6) gauge strap. The engine must have one strap, engine block and
transmission. (Use bolt that mounts transmission to rear face of engine block.) Allow slack loop for
engine motion. Use external star tooth washer between cable and frame.
7. Do not “splice” into existing wires, instead route wire full length to appropriate source.
8. If accessories must be added, relays may be required; check installation instructions thoroughly. Use
bank of circuit breakers in the electrical panel unless the accessory must be on during cranking, in
which case the “hot bar” should be used.
9. Always use insulated rubber boots over hot six (6) gauge wiring on alternator, ammeter shunt or
junction blocks.
Quick Reference
Wiring Circuit Color Code Major Circuits
FUNCTION COLOR
Left Rear Directional Light Yellow
Right Rear Directional Light Dark Green
Stoplights Red
Back-up Lights Blue
Taillights Brown
Ground White
Ignition Feed, Primary Feed Black
Refer to the master wiring diagram for wire colors for other circuits.
LIGHT BULB DATA
Lamp Description Trade Name Trade No. Color Bulb No.
INTERIOR LIGHTS
Driver & Passenger Transmatic 905-02-006 F13T5CW
Stepwell Arrow 35 67
Switch Panel Illum. Poly Optical 192
EXTERIOR LIGHTS
Directional Hella 6529OM 7506
Cluster & Marker KD 500-0120 Amber & Red 1895
KD 500-0620 Amber & Red 1895
Side Directional Peterson 122 194
Arrow 059-9900021CP 1073
Tail Hella 6544OM Red 5007
Back-UP Hella 65957 7506
Stop Hella 65333A Red 7506
Parking Hansen G570-0825 1156
License Plate Peterson 4365 168